From Cygnus Alpha
Jump to: navigation, search

eschaton config


sparc64 400MHZ 1Gb RAM

  1. uname -a

Linux netboot 2.6.32-gentoo-r7 #1 SMP Tue Apr 13 22:46:39 UTC 2010 sparc64 GNU/Linux netboot

  1. .

lom> break


lom> reset -x

ok> boot net:dhcp ... /etc/fstab

  1. <fs> <mountpoint> <type> <opts> <dump/pass>

/dev/hda1 / ext3 noatime 0 1 /dev/hda2 none swap sw 0 0

  1. /dev/hda3 none whole disk

/dev/hda4 /var ext3 noatime 0 1 /dev/hda5 /usr ext3 noatime 0 1 /dev/hda6 /usr/local ext3 noatime 0 1 /dev/hda7 /home ext3 defaults 0 1

proc /proc proc defaults 0 0 none /proc/openprom openpromfs defaults 0 0


mount /dev/hda1 /mnt/gentoo mount /dev/hda4 /mnt/gentoo/var mount /dev/hda5 /mnt/gentoo/usr mount -t proc none /mnt/gentoo/proc mount -o bind /dev /mnt/gentoo/dev


/etc/conf.d/hostname /etc/conf.d/net

rc-update net.eth1 default

netboot etc # ./init.d/net.eth1 start

* Caching service dependencies ...                                       [ ok ]
* Starting eth1
*   Bringing up eth1
                                                                         [ ok ]
*   Adding routes
*     default gw ...                                       [ ok ]

kernel netboot linux # make CROSS_COMPILE=sparc64-unknown-linux-gnu- Portage

Recreate the world file: Code: cp -p /var/lib/portage/world{,.bak} && emaint --fix all

Remember to remove all trace of portage from /var if recovering/updating. TWiki

  • To install twiki-4.3.1 into a virtual host, run the following command:
*     webapp-config -I -h <host> -d twiki twiki 4.3.1

You are almost done!

0. You will need to manually adjust permissions for the installation script to

  $ chown -R apache:apache /var/www/
  When you're done with the installation, don't forget to make sure that only
  the data/ and pub/ directories are writeable by the webserver!!!

1. Review /var/www/ and make sure all paths are set correctly

2. Take a look at twiki_httpd_conf.txt and modify your Apache configs as

  needed. Make sure your webserver can execute /var/www/
  Pay attention to the ExecCGI option (see

3. Visit

  Most values should have been automatically set for you.

4. Read the install guide